For a limited time only receive a FREE SET OF 12 CUTTER TEETH with your purchase of a manual start stump grinder.
If you’re ready to destroy stumps with ease, then this is your machine! The stump grinder has a cutting width of 2.1 inches and cuts approximately 16 inches down into the stump. It reduces stumps up to approximately 10 inches high, depending on the angle of the machine and the ground it’s operating on.
In addition, this machine has four handles for easy loading and unloading. The stump grinder is easy to start and extremely durable. No adjustments needed to be made or parts replaced after a 100-hour test. More stump grinder specifications are listed below:
14 HP Kohler® Engine | 11 Inch Circumference Cutter Head | Weighs 260 pounds | 12 Carbide-Hardened Teeth | Individually Exchangeable Teeth | Free Safety Glasses and Ear Protection
- 4-stroke OHV engine,420 ccm, 14 HP
- Centrifugal clutch
- Recoil starter
- Rotation speed: 3100 rpm
- The total weight (dry): 220 lbs
- Fuel type: regular unleaded
- Tank capacity: 1 gal.
- Fuel consumption: Approx. 3 – 4 hours run time
- Dimensions: 60x30x44 inches (LxWxH)
- Measurements of packaging: 43x32x32 inches
- Weight including packaging: 275lbs
THE VIDEO IS WITH OUR OLDER MOTOR – 13HP JD. ALL OTHER COMPONENTS ARE THE SAME!!!
***PLEASE NOTE VIDEO SHOWS OLD JD MOTER WE ARE WORKING ON A NEW VIDEO WITH 14HP KOHLER ENGINE***
Important: Shipping usually takes about 10-14 business days for residential addresses. It can take up to 4 weeks for some rural areas.
The estimated delivery time does not always reflect the actual delivery date. Liftgate requests and residential deliveries could add to the estimated delivery date.
Stump Grinder Manual Start FAQs
Can the teeth be sharpened?
Yes, but we do not offer a sharpening service.
Is the machine selfed propelled?
No, but it is very well balanced.
How big is the cutting wheel?
It has an 11” diameter cutting wheel. The cutting width is about 2”.
Can you replace the teeth individually?
Yes, there are 12 individually exchangeable carbide tipped teeth.
How often do I need to grease the cutter head?
Every 10 hours. This is very important.
Do you have parts in stock?
Yes, we have almost every part in stock at our warehouse in Arizona.
Key Notes and Tips
Please read the manual. It may save you a headache.
Keep an eye on the belt tension. Tighten it when needed.
Make sure the center bolt on the clutch stays tight.